The hottest South pump industry carries out measur

2022-09-23
  • Detail

Nanfang pump carries out measurement and testing training

any product needs to be measured. The purpose of measurement is to determine whether the product meets the requirements specified in the design. There will be errors in any measurement, and the size of identification error needs to be tested. In order to more effectively improve the familiarity of quality gatekeepers with the knowledge of measurement and inspection, the quality management center specially invites quality

any product needs to be measured. The purpose of measurement is to determine whether the product meets the requirements of the design. More time is invested in teaching practice and research. There will be errors in any measurement, and the size of identification error needs to be tested. In order to effectively improve the familiarity of quality gatekeepers with the knowledge of measurement and inspection, the quality management center specially invited the quality supervision department to carry out a measurement and inspection training for the whole company. Now let's approach the training site of measurement and inspection

at 15:30 p.m. on April 11, the training room on the fourth floor of the new canteen was full and the atmosphere was warm. A wonderful knowledge about measurement and inspection was in full swing. At the training site, there were not only quality inspectors from branch factories, but also quality inspectors from different subsidiary companies, such as Haozhuo, Nanfang Zhishui, foreign trade factory, nanpump fluid, etc. regardless of the distance, their active participation in this training had to make people admire their serious and studious spirit. We invited Manager Ma Meifang from the quality supervision department to explain this training to us. First of all, manager Ma told us the drawing information with professional and original views, including title block, technical requirements, views, abbreviations of dimension symbols, etc. It focuses on the abbreviations of dimension compliance, and lists the abbreviations of relevant dimension symbols one by one to the personnel present, and then expounds the use of vernier caliper, outside micrometer and inside dial gauge to the personnel present from the use of measuring tools. In order to enhance the understanding of environmental protection, manager Ma showed you the use steps of measuring tools and relevant precautions in actual measurement at the training site, At the end of the training, the common problems in ordinary measurement are added and analyzed and explained in detail. On the one hand, the measurement deviation caused by the operation methods that we need to pay attention to in use, on the other hand, the measurement deviation caused by omissions and errors, etc. It has benefited the people present a lot

through this training, we have a deeper understanding of the knowledge of measurement and inspection, and also understand the precautions in all aspects of measurement and inspection at ordinary times. The pressure sensor needs to be careful in every step of converting pressure signals into electrical signals. As the quality gatekeeper of products, we need not only accurate measurement level, but also meticulous inspection attitude. The negligence of any small detail can lead to the occurrence of batch accidents. The carefulness of each measurement and inspection determines the impact of the inspection results to varying degrees. As the quality gatekeeper, we must be careful and accurate step by step when dealing with measurement and inspection

Copyright © 2011 JIN SHI